A basin carved, not moulded.
Each Bellistri basin is cut from a single block of lava stone — round, rectangular or oval — and either left in its raw honed state or fired in any glaze from our enamel range. No two raw basins are quite the same.
Three shapes, left true to the stone
Round Basin
A deep round bowl, hand-honed to a raw matte face that keeps the full texture of the basalt.
Rectangular Basin
A clean-edged rectangular basin, left unglazed for a quiet, architectural look.
Oval Basin
A softly oval basin that pairs a raw honed exterior with a smooth interior bowl.
The same shapes, fired in colour
Every basin shape is also available in any glaze from the Bellistri colour range — a small selection is shown below across the three forms.
Round
Rectangular
Oval
Slim Wall-Mounted
Built for daily water
Raw honed basins develop a soft patina with use and benefit from an occasional stone sealer. Glazed basins are fully vitrified and non-porous, needing no maintenance beyond a wipe.
| Specification | Detail |
|---|---|
| Shapes | Round, rectangular, oval, slim wall-mounted |
| Finish options | Raw honed, or any fired enamel glaze |
| Mounting | Countertop / vessel-style |
| Drain fitting | Standard click-clack or plug, fitted to order |
| Lead time | 6–8 weeks |
Carved from a single block, not moulded from a mix
A cast composite basin is poured into a mould; a Bellistri basin is carved out of a solid block of Etna basalt, in our Catania workshop, by craftspeople who have shaped this stone for 27 years. The block is roughed out, then the bowl is hollowed and hand-finished to a true honed face — every raw basin keeps faint, natural variation in its grain, which is why no two are ever quite identical. A basin destined for a glaze is finished smooth first, then dipped and fired at 1000°C, the same process used across our worktops, tiles and tables, so a basin and worktop ordered in the same glaze come back an exact match.
Two finishes, two routines
Raw honed basins
Develop a soft, natural patina with years of use — part of the appeal of a raw stone piece. An occasional application of a standard stone sealer keeps the surface at its most water-resistant, though it is not strictly required. Clean with water and a mild, non-acidic detergent.
Glazed basins
Fully vitrified and non-porous — there is nothing to seal, ever. Wipe with water; avoid abrasive scouring pads over many years if you want to keep the glaze at its glossiest, though the fired surface itself will not scratch in normal use.
Frequently asked
Is a raw honed basin porous — will it stain?
It is far denser than marble or limestone and stains far less readily, but it is not fully sealed, so expect a slight, natural darkening with years of use. A glazed basin has none of this risk.
Can I match a basin to my worktop exactly?
Yes — every basin shape is available in any of our 58 fired glazes, the same palette used for worktops, tables and tiles, so a full room can be ordered in one exact colour.
Does it need a special counter or cut-out?
Most basins are countertop or vessel-style, sitting on or partly recessed into a worktop with a standard waste and tap cut-out, confirmed during templating.